|
|
单片机实现“叮咚”门铃的设计 6．汇编源程序 T5HZ EQU 30H T7HZ EQU 31H T05SA EQU 32H T05SB EQU 33H FLAG BIT 00H STOP BIT 01H SP1 BIT P3.7 ORG 00H LJMP START ORG 0BH LJMP INT_T0 START: MOV TMOD,#02H MOV TH0,#06H MOV TL0,#06H SETB ET0 SETB EA NSP: JB SP1,NSP LCALL DELY10MS JB SP1,NSP SETB TR0 MOV T5HZ,#00H MOV T7HZ,#00H MOV T05SA,#00H MOV T05SB,#00H CLR FLAG CLR STOP JNB STOP,$ LJMP NSP DELY10MS: MOV R6,#20 D1: MOV R7,#248 DJNZ R7,$ DJNZ R6,D1 RET INT_T0: INC T05SA MOV A,T05SA CJNE A,#100,NEXT MOV T05SA,#00H INC T05SB MOV A,T05SB CJNE A,#20,NEXT MOV T05SB,#00H JB FLAG,STP CPL FLAG LJMP NEXT STP: SETB STOP CLR TR0 LJMP DONE NEXT: JB FLAG,S5HZ INC T7HZ MOV A,T7HZ CJNE A,#03H,DONE MOV T7HZ,#00H CPL P1.0 LJMP DONE S5HZ: INC T5HZ MOV A,T5HZ CJNE A,#04H,DONE MOV T5HZ,#00H CPL P1.0 LJMP DONE DONE: RETI END 7． C语言源程序 #include unsigned char t5hz; unsigned char t7hz; unsigned int tcnt; bit stop; bit flag; void main(void) { unsigned char i,j; TMOD=0x02; TH0=0x06; TL0=0x06; ET0=1; EA=1; while(1) { if(P3_7==0) { for(i=10;i>0;i--) for(j=248;j>0;j--); if(P3_7==0) { t5hz=0; t7hz=0; tcnt=0; flag=0; stop=0; TR0=1; while(stop==0); } } } } void t0(void) interrupt 1 using 0 { tcnt++; if(tcnt==2000) { tcnt=0; if(flag==0) { flag=~flag; } else { stop=1; TR0=0; } } if(flag==0) { t7hz++; if(t7hz==3) { t7hz=0; P1_0=~P1_0; } } else { t5hz++; if(t5hz==4) { t5hz=0; P1_0=~P1_0; } } } |
|
|
|
|
|
|
|
学习单片机的必经之路——单片机之路,永久域名：www.mcuway.com
|
